GBA Logo horizontal Facebook LinkedIn Email Pinterest Twitter X Instagram YouTube Icon Navigation Search Icon Main Search Icon Video Play Icon Plus Icon Minus Icon Picture icon Hamburger Icon Close Icon Sorted

General Questions- Page 38 of 1409

  • Question & Answers

    it’s cold but sunny, how can I help my heat pump?

    I have to replace my furnace and AC soon since they are way past there lifetime.I have a lot of sun where I live butin the winter it gets cold…

  • Question & Answers

    flooring choices for finished basement with concrete-free floor

    We are about to do floors on our new Maine home: climate zone 6; sloped lot,  super-insulated (including concrete basement walls), concrete-free basement slab.  My contractor is concerned with my…

  • Question & Answers

    Do ridge vents really add value for low slope?

    I cant seem to find the smoke test video that showed no chimney effect in the tested roof section, but Im wondering if ridge-vent is really necessary for my 3:12…

  • Question & Answers

    How much cellulose is too much?

    Building a new construction in zone 6, rectangular home approximately 34x50 with R30 walls and a .50 ACH goal.  With that in mind, I'm trying to decide how much blown…

  • Question & Answers

    Insulating 1950s Brick over CMU Walls above grade Zone 5A

    Hi,I've found a lot of different advise about insulating CMU basement walls and Stucco over CMU on slab but I'm not finding anything about what would be best for a…

  • Question & Answers

    Preventing mould/moisture issues in shed/workshop

    Hi all,I am embarking on another build in the next 12 months. This site and others like it have been extremely useful in understanding more about building science. While I'm…

  • Question & Answers

    Plywood Forms for Concrete

    Hello,I am looking for advice on forming up my grade beams for my 1000 square ft. rectangle of a house.  Its for a concrete free slab/ sand box and the…

  • Question & Answers

    How to address gap under window sill

    I was pulling trim and notice that there is a gap between the window sill flashing and the vinyl siding channel. See photos.  My plan is to 1) stuff 3/8" or 1/2"…

  • Question & Answers

    Roofing felt under wood siding?

    Rather than using the newer synthetic building wraps, I would like to use a 30lb asphalt building paper, taping the plywood seams prior to minimize air leakage. The siding I'm…

  • Question & Answers

    Attic Temperature vs. Outdoor Temperature

    Greetings,Out of curiosity I put a temperature sensor in my attic and graphed the results against the outdoor temperature. It's been warm but not technically summer yet here in Southern…